Comtech-ef-data UT-4579 Instrukcja Użytkownika Strona 32
- Strona / 100
- Spis treści
- ROZWIĄZYWANIE PROBLEMÓW
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
UT4579 X-Band Up Converter MN/UT4579.IOM
System Operation Rev. 0
16
Table 8. Operating Functions – Front Panel
Item Reference Designation Functional Description
ENT
Enter key Enters commands into the converter.
CLR
Clear key Clears commands and data selected and not entered.
Right Arrow key Selects functions and the menu operating data.
Left Arrow key Selects functions and the menu operating data.
Up Arrow key Selects the operating menu and data values.
Down Arrow key Selects the operating menu and data values.
UT_4579-1
SW VER 4.06 SN45793513
LCD Display Displays commands and data entered
into the key-pad.
Indicator Color Function
POWER ON
Green
Prime power is applied when the light is on.
TRANSMIT
Yellow
Transmit function operating when the light is on.
REMOTE
Yellow
In Remote Control Mode when the light is on.
ON LINE
Yellow
Operating on-line to transmit data when the light is on.
FAULT
Red
Fault condition exists when the light is on.
STORED FAULT
Red
Faults stored and logged when the light is on.
Item Reference
Designation
Function
RF SAMPLE RF An SMA connector test point to sample RF.
IF SAMPLE IF A BNC connector test point to sample IF.
- UT-4579 1
- Errata A 3
- CUSTOMER SUPPORT 6
- Table of Contents 7
- Preface Rev. 0 10
- Figures 11
- ABOUT THIS MANUAL 13
- CONVENTIONS AND REFERENCES 13
- METRIC CONVERSION 13
- TRADEMARKS 13
- EMC COMPLIANCE 14
- SAFETY COMPLIANCE 15
- EN 60950 15
- WARRANTY POLICY 16
- Chapter 1. Introduction 17
- Figure 1. Front Panel 18
- 1.3 PHYSICAL CONFIGURATION 19
- 1.3.1 FRONT PANEL DISPLAY 20
- 1.3.3 PRIME POWER SWITCH 20
- 1.4 SPECIFICATIONS 21
- Introduction Rev. 0 22
- Chapter 2. Installation 25
- 2.3 PRIME POWER CONNECTION 26
- 2.4 CABLE CONNECTIONS 26
- Installation Rev. 0 27
- IF INPUT 30
- UP CONVERTER - TSM 30
- RF OUTPUT 30
- Chapter 3. System Operation 31
- UT_4579-1 32
- SW VER 4.06 SN45793513 32
- 3.2 SWITCHING POWER ON 33
- 3.3 OPERATION 33
- ---------SELECT 34
- --CURRENT-FAULTS-MENU 34
- ----CONFIGURATION-MENU 35
- ---MONITOR-STATUS-MENU 38
- ---CURRENT-FAULTS-MENU 39
- -UTILITY-FUNCTIONS-MENU 40
- 3.3.1 CONVERTER COMMANDS 41
- System Operation Rev. 0 42
- 3.3.7 UTILITY FUNCTION MENU 45
- Appendix A. Redundant System 47
- Operation 47
- A.2 BACKUP CONVERTER 48
- A.3 REDUNDANT CONFIGURATIONS 49
- A.4.1 INITIAL CONFIGURATION 55
- CONV-01-OFFSET=+00.00-DB 57
- REDUNDANCY-CONFIG?-ON 57
- -CONVERTER-#-02 57
- -CONVERTER-#-03 57
- -ACTIVATE-BACKUP:-FORCED 59
- A.4.4 OFFSET ADJUSTMENT 60
- Appendix B. Remote Control 63
- B.2 PROTOCOL 64
- B.3 ACCESS METHODS 65
- B.4 ADDRESSES 66
- B.5 MESSAGE STRUCTURE 67
- B.5.5 ERROR RESPONSE 68
- B.5.6 END OF MESSAGE 68
- B.5.6.1 COMMAND ENDING 68
- B.5.6.2 RESPONSE ENDING 68
- B.6 COMMAND / RESPONSE PAIRS 69
- B.6.1.5 LCD CONTRAST 70
- B.6.1.6 LCD BRIGHTNESS 70
- B.6.1.9 EQUIPMENT TYPE 71
- B.6.2 CONFIGURATION COMMANDS 72
- B.6.2.1 F 72
- B.6.2.2 ATTENUATOR 73
- B.6.2.3 COLD START 73
- B.6.2.4 MUTE 73
- B.6.2.5 AUTO FAULT RECOVERY 74
- B.6.2.6 PROGRAM PRESET 74
- B.6.2.7 DISPLAY ALL PRESETS 74
- B.6.2.8 CLEAR PRESET 75
- B.6.2.9 SELECT A PRESET 75
- B.6.3 MODES 75
- B.6.3.1 REDUNDANCY MODE 75
- UTOMATIC/MANUAL MODE 76
- B.6.3.3 BACKUP MODE 77
- B.6.4 STATUS COMMANDS 77
- B.6.4.1 CONFIGURATION STATUS 77
- B.6.4.2 MAINTENANCE STATUS 78
- B.6.4.3 UTILITY STATUS 78
- B.6.4.4 ALARM STATUS 78
- B.6.4.5 SUMMARY ALARM STATUS 79
- ACKED MAINTENANCE STATUS 80
- ACKED UTILITY STATUS 80
- B.6.4.10 PACKED ALARM STATUS 81
- B.6.5 STORED ALARM 81
- B.6.5.1 TOTAL STORED ALARMS 81
- B.6.5.3 LIST ALL ALARMS 82
- B.7 ERROR PROCESSING 83
- Remote Control Rev. 0 84
- C.1 APPLICATIONS 87
- C.2 RF SIGNAL CONVERSION 88
- Theory of Operation Rev. 0 89
- C.3 MONITOR & CONTROL 90
- Appendix D. Maintenance and 91
- Troubleshooting 91
- D.2 MAINTENANCE TESTING 92
- D.2.2 TROUBLESHOOTING 93
- D.2.3 CONVERTER FAULTS 93
- D.2.3.1 PRIME POWER 93
- D.2.3.3 RF CONVERTER MODULE 94
- D.2.3.7 TEMPERATURE FAULT 94
- D.3 SPARE 95
- Index Rev. 0 98
- METRIC CONVERSIONS 99
- Units of Length 99
- Temperature Conversions 99
- Units of Weight 99
- 480 • 333 • 2200 Phone 100
- 480 • 333 • 2161 FAX 100
Powiązane produkty i podręczniki dla Ekwipunek Comtech-ef-data UT-4579
Ekwipunek Comtech-ef-data KPA Instrukcja Użytkownika
(128 strony)
(128 strony)
Ekwipunek Comtech-ef-data CPA Instrukcja Użytkownika
(138 strony)
(138 strony)
© 2020, manymanuals.pl. Wszelkie prawa zastrzeżone. | 0.043 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji