Comtech-ef-data CDM-IP Quick-Start Guide Instrukcja Użytkownika Pobierz pdf (Strona 17)

CDM-IP Quick Start Guide Rev. 0

Getting Started CD/CDMIPQSG.IOM

From the Interface Configuration menu, select Satellite/HDLC Interface (hdl0) [H].

From the Satellite/HDLC Interface (hdl0) menu, select HDLC Addr Mode [M].

Confirm when prompted by typing ‘y’ when the following prompt is displayed;

Changing HDLC address mode causes system Reboot.

Do you want to continue(Y/N)[Enter :No]

Select [1] for Small Network Mode.

Allow CDM-IP to reboot. After reboot, select Interface Configuration [I] from the Main

Menu.

From the Interface Configuration menu, select Receive HDLC Channel Addresses

[H].

From the Receive HDLC Channel Addresses menu, select [1] for HDLC Addr 1. The

following prompt will be displayed;

Please enter a value for the HDLC Addr 1

Press ESC to abort

HDLC address [SMALL NETWORK] in hex <0x1 - 0xFE, enter = 0001>:

Enter [2] to set HDLC Addr 1 to 0x01.

Note: HDLC Addr 1 will display as 0x0001, although only the last 2 digits are used in

Small Network Mode, allowing up to 254 separate HDLC addresses.

Repeat Steps 1 - 9 on CDM-IP 2. Also, repeat Step 10, but set HDLC Addr 1 to 0x02.

Both CDM-IP modems are now in Router/Small Network Mode, which will means that

the CDM-IP modems will be on independent IP subnets and will require adding static

routes to pass traffic between them.

Section 1.3.4, Route Table, explains this procedure.

1.3.3 SETTING IP ADDRESS(ES)

Step Description

From the Main Menu select Interface Configuration sub-menu [I].

From the Interface Configuration Menu select Ethernet Interface (fei0) sub-menu [E].

Set IP Address [I].

CDM-IP 1 to 172.16.10.1

CDM-IP 2 to 172.17.10.1

Set Subnet Prefix Length [M] to 24

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Brak uwag

Comtech-ef-data CDM-IP Quick-Start Guide Instrukcja Użytkownika Strona 17